Product
D-2100 WET HORIZONTAL UNIT
GENERAL DESCRIPTION
The Magnaflux® D Series (3 Phase Units) are our most powerful standard wet bench units. They offe magnetization for finding surface and sub-surface defects while using minimal power. The two output are independently adjustable to set each magnetic field, circular or longitudinal.
BENEFITS
- High output for inspection of large parts
- Ability to locate sub-surface defects using DC
- Shot time can be adjusted to meet different inspection requirements or needs
- Footswitch to free-up hands for inspection
EXTERIOR
- Innovative pump system for fluid delivery, agitation with easy maintenance access
- Push bar design for easy activation
- Current assurance indicator for magnetic current flow
- Large, easy to read Digital Ammeter
- Independent Contact and Coil Current Controls
- 16 inch (41 cm) diameter coil
- Footswitch-activates pneumatic headstock
- Adjustable tailstock with crank
- Stainless steel tank
- Front and rear maple hardwood grilles
INTERIOR
- Microprocessor control advanced technology; reduce components and increase reliability
- RS-232 port for computer interface
- Solid state circuitry
- Quick break on coil circuit
- Liquid Resistant panels, allow ventilation while inhibiting fluid intrusion
Specifications
- 10,000 amp Three (3) Phase Rectified to FWDC magnetizing current capability at contacts
- Ultra Low Frequency reversing DC Demagnetization
- Duty Cycle 0.5 seconds on, 20 Seconds off (Maximum of 5 seconds)
- 54 inch (137 cm) headstock/tailstock capacity
- Infinitely variable current control
- Available Voltages: 230, 380, 415, 460, 575, 50 or 60 hertz, 3 phase power
- Recommended 20 Gallon (75 Liter) Tank Fluid Capacity
- Minimum 80 PSI with 5 SCFM capability
- 89” (224 cm) x 41” (104 cm) Foot Print, allow 24”(61 cm) per side for ventilation